How to Level a Washing Machine? Step by Step Guide

Read Time:3 Minute, 59 Second

A tidy, well-organized laundry room may be a productive area to do duties. A washing machine that vibrates excessively or rattles the entire home during the spin cycle, on the other hand, interrupts the refuge you envision. When the washing machine shakes, it can harm internal systems as well as anything nearby, including the walls and floor.

The issue is straightforward: the machine is not sitting level.

Fortunately, the solution is just as straightforward, due to screw-up and screw-down adjustable legs. This makes learning how to level a washing machine without expert aid simple. Simply follow these steps.

Table of Contents

Why Do Washing Machines Go Out of Level?

Out-of-level washing machines can be caused by flooring concerns, impediments under the machine, or incorrectly positioned front legs. Typical reasons include:

deteriorated floor covering
Inadequate subfloor and joists
The machine is lying on a soft surface, such as carpeting.
The floor is not level.
Spins displacement machine with inadequately loaded or heavy goods such as bedcovers
The height of the machine feet changes with time.
Front-loading washing machines spin quicker than top-loading washing machines, resulting in misalignment.
Out of alignment plastic washing machine pan
Under washer feet, place heavy-duty anti-vibration pads.

When Should You Level Your Washing Machine?

Only level a washing machine when the drum is completely empty. If it is safe, start the spin cycle to empty the drum. Otherwise, use a kitchen measuring cup to manually drain the water.

Level a washing machine right away. Outside of the manufacturer’s suggested maximum slope, there is no safe operating slope for washing machines.

How to Level a Washing Machine?

Step 1: Check to see if the machine is level:

Use a carpenter’s bubble level or a phone app that is similar to this equipment. Set your gadget of choice on top of the machine and check its level from side to side and then front to back. If the bubble does not center itself, you will need to make some adjustments.

Step 2: Loosen the lock nut:

The two front legs of the washing machine screw up and down. You must first loosen the lock nut on each before you can adjust them.

Step 3: Adjust the front legs:

If the machine rests low to the ground, it is less likely to vibrate. Screw one leg all the way in and adjust the others as needed until the washer sits flat according to your carpenter’s level or Smartphone app.

Step 4: Examine the back legs:

Most washing machines feature self-leveling back legs. Once the appliance is level from side to side, have a second person assist you in tipping it forward so the back legs elevate three or four inches off the floor. When you replace the washer, the legs should automatically adjust so that the machine sits level from front to back. However, some washing machines feature movable legs in the back as well as the front. In this situation, you must manually adjust the back legs until the machine is level.

Step 5: Check your washer every few months:

Your house might settle with time and even vary from season to season. If you observe significant vibrations, check the level of the washer. Remember that uneven clothes in a top-loader might create shaking during the spin cycle, so load each batch equally. Check the balance of your front-loading machine every few months, as these appliances have far faster spin rates than top-loaders.